Leed Points


INALCO declares that by means if its ECOINALCO manufacturing policy, its high quality products contribute towards obtaining LEED points thanks to their manufacturing system based in the reduction, re-use and recycling of waste material.

CONTRIBUTION ON INALCO'S WALL AND FLOOR PRODUCTS TO THE OBTAINMENT OF LEED POINTS:

LEED RATING CLEED CREDIT REQUIREMENT POINTS
Standard thickness
(10,5 / 10 mm)
Slimmker
(6 mm)
SUSTAINABLE SITES Reduction of heat island Outer cladding materials with a Solar Reflectance Index SRI> 32 1 - 2 1 - 2
MATERIALS AND RESOURCES Sources of raw materials Post-consumer + 1/2 pre-consumer content 1 1
ENVIRONMENTAL QUALITY INTERIORS Low-emission materials The established VOC limits for indoor wall cladding must not be exceeded 1 - 3 1 - 3
Thermal comfort The building shell must be planned to comply with the requirements of ASHRAE 5-2010 1 1
INNOVATION IN DESIGN Innovation Outstanding strategies must be provided that surpass the requirements established by LEED 1 - 3

CONTRIBUTION ON INALCO'S ITOP PRODUCTS TO THE OBTAINMENT OF LEED POINTS:

LEED RATIG LEED CREDIT REQUIRIMENT POINTS
ITOP
COUNTERTOPS
(20 / 12 mm)
ITOP
COUNTERTOPS / FRONTS
(6 / 4 mm)
SUSTAINABLE SITES Reduction of heat island Outer cladding materials with a Solar Reflectance Index SRI> 32 1 - 2 1 - 2
MATERIALS AND RESOURCES Sources of raw materials Post-consumer + 1/2 pre-consumer content 1 1
ENVIRONMENTAL QUALITY INTERIORS Low-emission materials The established VOC limits for indoor wall cladding must not be exceeded 1 - 3 1 - 3
Thermal comfort The building shell must be planned to comply with the requirements of ASHRAE 5-2010 1 1
INNOVATION IN DESIGN Innovation Outstanding strategies must be provided that surpass the requirements established by LEED 1 - 3

Calle San Salvador, nº 54.
12110 Alcora (Castellón) SPAIN

Tel. (+34) 964 368 000
Fax: (+34) 964 368 050

e-mail: correo@inalco.es

© INALCO 2019