LEED POINTS


 

Inalco declares that by means if its  manufacturing policy, its high quality products contribute towards obtaining LEED points thanks to their manufacturing system based in the reduction, re-use and recycling of waste material.

CONTRIBUTION ON INALCO'S WALL AND FLOOR PRODUCTS TO THE OBTAINMENT OF LEED POINTS:

LEED RATING CLEED CREDIT REQUIREMENT POINTS
Standard thickness
(20 / 10,5 mm)
Slimmker
(6 mm)
SUSTAINABLE SITES Reduction of heat island Outer cladding materials with a Solar Reflectance Index SRI> 32 1 - 2 1 - 2
MATERIALS AND RESOURCES Sources of raw materials Post-consumer + 1/2 pre-consumer content 1 1
ENVIRONMENTAL QUALITY INTERIORS Low-emission materials The established VOC limits for indoor wall cladding must not be exceeded 1 - 3 1 - 3
Thermal comfort The building shell must be planned to comply with the requirements of ASHRAE 5-2010 1 1
INNOVATION IN DESIGN Innovation Outstanding strategies must be provided that surpass the requirements established by LEED 1 - 3

CONTRIBUTION ON INALCO'S ITOP PRODUCTS TO THE OBTAINMENT OF LEED POINTS:

LEED RATIG LEED CREDIT REQUIRIMENT POINTS
ITOP
COUNTERTOPS
(20 / 12 mm)
ITOP
COUNTERTOPS / FRONTS
(6 / 4 mm)
SUSTAINABLE SITES Reduction of heat island Outer cladding materials with a Solar Reflectance Index SRI> 32 1 - 2 1 - 2
MATERIALS AND RESOURCES Sources of raw materials Post-consumer + 1/2 pre-consumer content 1 1
ENVIRONMENTAL QUALITY INTERIORS Low-emission materials The established VOC limits for indoor wall cladding must not be exceeded 1 - 3 1 - 3
Thermal comfort The building shell must be planned to comply with the requirements of ASHRAE 5-2010 1 1
INNOVATION IN DESIGN Innovation Outstanding strategies must be provided that surpass the requirements established by LEED 1 - 3
Do you want additional information?
I have read and I accept the legal terms
SEND
© INALCO 2021